[Chimera-users] models disappear after using "split"
aleschziner at ucsd.edu
Fri Feb 24 15:21:42 PST 2017
I used “split” to break a model into its 19 component chains. The chains appear in the Model Panel and are marked as “Shown" but are gone from the display. Everything else I have in the session works normally but nothing I have tried so far makes the split models show up.
Any help solving this would be much appreciated!
Department of Cellular and Molecular Medicine
and Section of Molecular Biology, Division of Biological Sciences
University of California, San Diego
9500 Gilman Dr.
La Jolla, CA 92093-0694
aleschziner at ucsd.edu<mailto:aleschziner at ucsd.edu>
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Chimera-users