[Chimera-users] MultiScale.color_surfaces_to_match_atoms() and MultiScale mesh resolution ???
darrellh at niaid.nih.gov
Wed Aug 20 07:46:16 PDT 2008
I¹m trying to use the command MultiScale.color_surfaces_to_match_atoms(). I
want to point out a mutation on the surface of a virus. I can color the
atoms correctly, but I can¹t figure out how to apply that color to the
MultiScale low-resolution surface. Any hints on how to use this command?
Also, how can I increase the mesh resolution on MultiScale surfaces for
input for 3D printing?
NIH Researchers: check out our new web site
Darrell Hurt, Ph.D.
Section Head, Biocomputing Research Consulting
Bioinformatics and Scientific IT Program (BSIP)
NIAID Office of Technology Information Systems (OTIS)
National Institutes of Health, DHHS
Contractor, Lockheed Martin
4 Memorial Drive, Room 424
Bethesda, MD 20892-0485
Mobile: (301) 758-3559
Fax: (301) 402-0366
NIAID Intranet: http://bioinformatics.niaid.nih.gov
The information in this e-mail and any of its attachments is confidential
and may contain sensitive information. It should not be used by anyone who
is not the original intended recipient. If you have received this e-mail in
error please inform the sender and delete it from your mailbox or any other
storage devices. National Institute of Allergy and Infectious Diseases shall
not accept liability for any statements made that are sender's own and not
expressly made on behalf of the NIAID by one of its representatives.
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Chimera-users